Install Part I - Hardware - Install and Power-on the SecureAuth IdP 9.1+ Appliance

Introduction

Use this guide to prepare and setup the SecureAuth IdP 2012 R2 Hardware Appliance for the guided installation.

Prerequisites

Complete a pre-deployment meeting with your Sales Engineer
Review and complete the Pre-Deployment Requirements section of Getting Started I - Pre-Install

Set up the SecureAuth IdP 2012 Hardware Appliance

1. Connect the power and NIC1 cables to the SecureAuth IdP appliance

Tip

It may be helpful to connect a KVM or console to configure the TCP/ IP stack on the appliance. By default, the appliance is configured to use DHCP for IP address assignment.

2. Power on the appliance

3. The Operating System Setup begins; the following notices display on the screen while these processes complete:

Setup is installing devices
Setup is starting services
Setup continues after restarting your computer

4. On the next boot, the Setup Windows dialogue displays

Additional Information

What's Next

When you have completed all steps on this page, move on to Install Part II - Initialize the SecureAuth IdP Setup Utility